How to Maintenance Eco Solvent Printer and Solvent Printer

• Q

  19. All the four colors can’t jet

  A

  Possible reasons: The system guider is incorrect; the problems of the printhead board; the long data link probable destroyed. Solutions: Re-upload the system data; change the headboard; change the data link.
• Q

  20. Some Vertical stripes appears on the image

  A

  Possible reasons: The printing material can’t adsorb ink; the linear rail guider is dusty; errors occur on data translation; the wheel and the transportation belt loosen; the printheads may be used too long. Solutions: Change printing material; clear the linear rail guider with alcohol; re-transport the data; twist tightly of the screw of transmission or change the belt; change the new printheads.
• Q

  21. The half nozzles of printhead don’t jet ink

  A

  Possible reasons: The data links are not tight; the ink supply system is not smooth; the printheads been clogged; the main board and the printhead board cannot use at the same time; the main board has been broken already. Solutions: Re-contact the data link (Note: can’t pull out the data link with power, otherwise the printheads are easy destroyed); check all of the parts and the connector of the ink supply system; can’t let the air enter; clean the printheads or change the printheads; use the shared main board, I/O board, and printhead board; change the printhead board.
• Q

  22. The ink outflow after fulfill printing

  A

  Possible reasons: The ink jet too much, the heat plate didn’t start; the indoor temperature and humidity is too high. Solutions: Decrease the inkjet quantity; start the heat plate; lower the indoor temperature and the humidity.
• Q

  23. The printing material runs inaccurately

  A

  Possible reasons: The ink jet too much; the heat plate didn’t start working; the indoor temperature and humidity is too high. Solutions: Decrease the printouts quantity; start the heat plate; lower the indoor temperature and the humidity; the printing material clamps loosen, the whole machine isn’t at the same level.
• Q

  24. Messy code

  A

  Possible reasons: The power source is not stable; the ground wire didn’t assemble well; operate illegally; the net disturb the computer; some problems on the printhead board or the main board. Solutions: Must assemble one UPS that the power as M3 3000. Firstly it can reduce the disturb from outdoor; secondly avoid the power off; every machine must assemble the ground wire and suggest assemble the ground wire on the hull of the host computer. Before every printing, suggest re-set the feature of the former image to avoid illegal operation once on printing process.